Best Practices

Setting Paste Height and Volume Control Limits: SPC, Cpk and GR&R

How to turn paste measurements into process control: choosing limits, checking your gauge and reading the charts.

November 17, 2026 · 7 min read

A solder paste inspection system produces numbers. Whether those numbers improve your yield depends on the limits you set and how you respond to them. This is a practical guide to both.

Specification limits and control limits are different things

Specification limits say what is acceptable: outside them, the board is wiped and reprinted. Control limits describe how the process normally behaves: outside them, something has changed and should be investigated, even if the boards are still within specification. Mixing the two up is the most common mistake in paste process control.

Choosing specification limits

A widely used starting point is to accept paste volume between roughly 50% and 150% of the nominal aperture volume, with tighter limits for fine-pitch and area-array parts. Treat that as a starting point only. The right limits depend on the component, the pad design and what your reflow results show.

  • Set limits per component type, not one set for the whole board.
  • Tighten the lower limit where opens are the risk, such as BGAs and small passives.
  • Tighten the upper limit where bridging is the risk, such as fine-pitch leaded parts.
  • Remember that small apertures naturally transfer less than 100% of their volume. The nominal for a low area-ratio aperture may be well under the theoretical figure.

Check the gauge before trusting the data

A gauge repeatability and reproducibility (GR&R) study measures how much of the variation you see comes from the measuring system. If the gauge is noisy, you will chase problems that do not exist. The common guideline is that GR&R under 10% of the tolerance is good, 10 to 30% may be acceptable depending on the application, and over 30% is not.

Run the study on real printed boards as well as a calibration standard, and repeat it with different operators if the system is manually loaded.

Establish control limits from your own process

  1. Run the process under normal, stable conditions.
  2. Collect at least 25 subgroups, for example five pads of the same type on each of 25 boards.
  3. Calculate the average and the range for each subgroup.
  4. Set control limits at three standard deviations either side of the overall average. SPC software does this automatically.

These limits are almost always tighter than the specification limits. That is the point: they warn you early.

Process capability: Cp and Cpk

Cp compares the width of the specification to the width of the process spread. Cpk does the same but accounts for a process that is off-center. A Cpk of 1.0 means the process just fits inside the specification. A value of 1.33 or more is a common target; many automotive and high-reliability customers ask for 1.67.

A low Cpk with a high Cp means the process is consistent but off-target, which is usually an easy correction. Low values of both mean there is too much variation, which takes more work.

Reading the charts

PatternLikely cause
Height trending down over many printsStencil apertures clogging; wipe frequency too low
Sudden step changeNew paste jar, stencil change, operator adjustment
Low volume in one area of the boardInadequate board support or uneven squeegee pressure
High height with peaks at pad edgesSeparation speed or poor gasketing
Scooped large padsExcess squeegee pressure or soft blade
Gradual change through the shiftPaste drying out; temperature or humidity change
Offset growing in one directionStencil or board alignment; stretch

React to trends, not just failures

Define in advance what an operator does when a point falls outside the control limits or when several points in a row move in one direction: check the stencil, check the paste, call the process engineer. A system whose warnings are ignored becomes an expensive sorting station.

Specification limits protect the customer. Control limits protect the process. You need both, and a gauge good enough to tell them apart.

Questions About Your Own Line?

Our engineers are glad to talk through your process and what inspection could do for it.