Buyer's Guide

SPI Buyer's Guide: Questions to Ask Before You Buy

A practical checklist for evaluating solder paste inspection systems: measurement performance, usability, total cost and, above all, who stands behind the machine.

November 17, 2026 · 7 min read

Solder paste inspection systems look similar on a data sheet. They differ in how well they measure your boards, how much effort they take to run, and what they cost over ten years. These questions will draw out the differences.

1. What do you need it to do?

Decide this before you talk to anyone. Do you need to verify setups and sample during a run, or measure every pad on every board? What is your smallest aperture and finest pitch? How many different products do you run in a week? The answers determine whether a benchtop or a fully automatic system is the right class of machine, and they stop you paying for capability you will not use.

2. How is repeatability demonstrated?

Resolution is not accuracy and neither is repeatability. Ask for a gauge repeatability and reproducibility (GR&R) result, how it was obtained, and on what: a calibration standard or real paste on a real board. Then ask to repeat it on your own board during the evaluation. A capable system and a confident supplier will agree.

3. How does it handle real boards?

  • Board warpage: is the reference plane found locally, or assumed flat?
  • Different surface finishes, solder mask colors and silkscreen near pads.
  • Very small deposits and very fine pitch.
  • Shadowing from tall features near the pad.

Bring your most difficult board to the demonstration, not your easiest.

4. How long does programming take?

On a high-mix line, programming time matters more than cycle time. Ask to watch a new board being set up from Gerber data, start to finish, and time it. Ask what an operator has to know, as opposed to an engineer.

5. What happens to the data?

You are buying the measurements as much as the machine. Check that SPC charts are built in, that data can be exported in open formats, and that you can get at it without buying extra software.

6. What does it cost to own?

  • Is the software a one-time purchase or an annual license?
  • Are software updates included?
  • What does annual calibration involve, and can you do it yourself?
  • Which parts wear out, what do they cost and how long do they take to arrive?
  • Is a service contract optional?

Systems with solid-state light sources and few moving parts have less to maintain. Ask what the maintenance schedule actually is.

7. Who designed and built it?

This question is asked less often than it should be. Inspection equipment is sold by original manufacturers, by companies that put their own name on another maker’s machine, and by dealers in pre-owned equipment. Each can be a reasonable choice, but they are different propositions.

  • Who wrote the measurement software, and can the seller change it?
  • When you have a measurement problem, will you talk to someone who understands the algorithm?
  • Who holds spare parts, and for how many years are they committed to do so?
  • If the seller and the maker part ways, who supports your machine?

8. What does support look like in practice?

Ask for the escalation path, in names and roles. With an original manufacturer the path is short: the people who designed the system are the last line of support. Ask how application questions, not only breakdowns, are handled.

Evaluation checklist

AreaEvidence to ask for
MeasurementGR&R on your board, repeated in front of you
UsabilityTimed programming of a new board
DataExport sample and SPC screens
Cost of ownershipWritten five-year cost including licenses and service
OriginWho designs, builds and supports the system
SupportNamed escalation path and spare parts commitment

Questions About Your Own Line?

Our engineers are glad to talk through your process and what inspection could do for it.